0 items in your basket
Total £ 0.00 EX VAT
MIG Gloves
TIG Gloves
Baseball Caps
Armguards
TIG Heat Blockers
Shop 55,000 Products
SERVICEDEPT.
RAPID BLOG
FEEDBACK
HIRE
Practical answers on choosing, fitting and getting the best life from the all-in-one cartridges used in machine-mounted plasma cutting torches.
A cartridge is a single replacement part that takes the place of the separate consumables in a traditional torch stack. On air plasma systems it combines the shield, retaining cap, nozzle, electrode and swirl ring into one assembly, so it can be fitted in seconds and the parts stay aligned.Because the parts are made and wear together, makers say a cartridge can last longer than a loose stack and gives less chance of fitting the wrong combination. Cartridges are usually colour coded by use. Always match the cartridge to your torch and power supply using the parts guide.
Replace it when cut quality starts to fall, which is usually well before it fails. Maker guidance links a worn cartridge to rougher edges, more dross, a wider kerf, bevelled cuts and slower cutting. Look at the nozzle opening in the cartridge: if it is notched or egg-shaped, or the outer shield or retaining cap is badly worn or damaged, replace the cartridge. Some systems also stop the arc and show a warning when they detect that the cartridge has reached end of life.That warning is a safeguard, not a target. A cartridge that fails on the torch can damage the torch itself.
The two are designed differently. A cutting cartridge produces a narrow, focused arc to sever metal, while a gouging cartridge shapes the arc to remove metal and wash out welds and defects. Maker troubleshooting guidance for poor cut quality specifically says to use a gouging cartridge in gouge mode and a cutting cartridge in cut mode.Using the wrong pairing gives poor results and can shorten cartridge life. Gouging cartridges also come in lighter and heavier removal profiles, so choose the one that suits the job and check the parts guide for your torch.
Yes. Plasma makers specify clean, dry, oil-free air and refer to the ISO 8573-1 air quality classes in their manuals. Oil, water and other contaminants can damage the internal parts over time, and poor air quality is listed as a cause of lower cut quality and speed, reduced cutting thickness and shorter consumable life.Any compressor feeding the system needs filtration to remove oil, and an extra filter or dryer at the machine inlet is often worthwhile. Check the target class and the pressure range in the manual for your power supply.
