0 items in your basket
Total £ 0.00 EX VAT
MIG Gloves
TIG Gloves
Baseball Caps
Armguards
TIG Heat Blockers
Shop 55,000 Products
SERVICEDEPT.
RAPID BLOG
FEEDBACK
HIRE
Answers to common questions about single-piece cartridge consumables and adaptors for hand-held plasma torches.
A cartridge is a single-piece consumable that takes the place of the separate parts in a traditional air plasma torch stack, normally the shield, retaining cap, nozzle, electrode and swirl ring. Because it is made as one piece, the parts stay aligned with each other, and fitting it is usually a matter of placing it on the torch and giving it a quarter turn.The main benefits are quick changes and consistent alignment, and because all the working parts wear together you replace the whole cartridge rather than checking each part. Always use the type your torch and plasma system are designed for.
Some modern plasma systems detect that a cartridge has reached the end of its life and stop the arc with a warning, so you do not have to judge it by eye. Not every system or torch combination gives this signal, so check your manual.Most operators change a cartridge sooner, once cut quality starts to fall. Typical signs are a wider, rougher or more bevelled cut, more dross on the underside and slower cutting. Look at the nozzle opening in the cartridge: if it is notched or egg-shaped, replace the cartridge. Do not keep using a worn one, because a failing cartridge can damage the torch itself.
A drag cutting cartridge is designed so the front of the torch can rest on, or be lightly dragged along, the workpiece while cutting. This means you do not have to hold a set gap by hand, which many operators find easier, especially on longer straight cuts or when following a line or a guide.It is a hand-cutting option rather than a different kind of machine. Dragging is intended only for consumables made for it, so do not drag a cartridge that is meant to be used with a held standoff. Your manual and cutting data will show the thicknesses and current settings the cartridge is designed for.
Cutting forces a tightly constricted arc through the metal to separate it. Gouging uses a wider, less focused arc and a torch held at an angle, so the metal is melted from the surface and blown to one side to leave a groove without cutting through. That is why gouging has its own consumables, with a larger nozzle opening than a cutting nozzle.Gouging types usually include a control type for shallow work and beginners, a high-removal type for deep or heavy work, and a precision type for removing small amounts at low current. Many plasma systems have a gouging mode, so check the setting before you start.
