0 items in your basket
Total £ 0.00 EX VAT
MIG Gloves
TIG Gloves
Baseball Caps
Armguards
TIG Heat Blockers
Shop 55,000 Products
SERVICEDEPT.
RAPID BLOG
FEEDBACK
HIRE
For use with Mono Cable torches when the machine has a separate gas connection.
Answers for buyers choosing and fitting the power adaptors and hose connections that join a TIG torch to the welding machine and cooler.
Water-cooled torches have a coolant supply and a return hose, and on some torches the hoses or the cooler connectors are marked or colour-coded. The markings are not the same on every make, so do not rely on colour alone. Identify each hose from your torch manual and match it to the cooler connections shown in the cooler manual.Connecting the hoses the wrong way round, or mixing up the water and gas hoses, can stop the coolant circulating properly and the torch may overheat. If you are fitting a new cable assembly, check the hose connections before you switch the cooler on.
Follow the tightening method in your torch and machine manuals, because it differs between makers. Some specify hand-tightening of power and control connectors, while others call for the correct spanners or pliers on the hose and power cable fittings. Do not use excessive force, and do not use tools where the manual says hand tight.Loose connectors can overheat, cause poor electrical contact, damage the parts and lead to water or gas leaks. A power connector that feels hot in use, or that no longer seats firmly, should be checked before you carry on.
Yes, it is good practice. Torch makers advise flushing the gas line and purging the regulator and torch with shielding gas whenever fittings have been detached, so that air trapped in the hose and torch is pushed out before you weld. Otherwise that air can reach the weld.The flow rate and time depend on the torch, the hose length and the manufacturer's instructions, so follow your manual rather than a fixed figure.
In TIG welding, porosity is most often caused by contamination or by a loss of gas shielding. A leaking hose joint, a poorly seated adaptor or a loose fitting can let gas escape or let air be drawn in, so the weld pool is not properly protected.If you see porosity, check the gas connections and hoses as well as the usual causes such as dirty material and draughts.
