0 items in your basket
Total £ 0.00 EX VAT
MIG Gloves
TIG Gloves
Baseball Caps
Armguards
TIG Heat Blockers
Shop 55,000 Products
SERVICEDEPT.
RAPID BLOG
FEEDBACK
HIRE
Plasma torch spares for one maker's cutters: how to match the right part, spot wear and fit it safely.
The nozzle focuses the arc through a small round hole. Signs of wear include erosion around the hole, a hole that is no longer circular, blocked gas holes and damaged O-rings on the outside.On the cut itself, a worn nozzle usually gives a wider kerf, more dross on the underside and a bevelled or ragged edge. If cut quality drops and nothing else has changed, inspect the nozzle and electrode together. A damaged nozzle should be replaced, not cleaned up and refitted, because the hole shape controls the arc.
Switch off first, then remove the old parts and wipe the inside and outside of the torch head with a clean, lint-free cloth. Check the seating faces and threads for dirt, burn marks or damage, and look for debris that the retaining cap can trap.Examine the O-rings for cracks, flattening or cuts and replace any that are damaged. Check the swirl ring holes for dirt, cracks or blockages. If you wash parts, use clean tap water, not water from a cutting table, as its contaminants can harm consumables. Make sure everything is dry and clean before assembly.
Only a very thin film of the silicone lubricant recommended in your manual, and only on O-rings that look dry. A correctly lubricated O-ring has a slight shine.Too much grease can block gas passages, attract metal dust and lead to poor arc behaviour or damage, so wipe off any excess with a lint-free cloth. Do not grease the threads or the torch body unless the manual says so. If an O-ring is worn, split or flattened, replace it instead of trying to rescue it with more lubricant.
Yes. Moisture and oil in the air supply reach the torch and can significantly shorten consumable life, spoil cut quality and may damage the torch and power source. Condensation can form in air lines as temperatures change, and oil can find its way back from air tools on the same line.A good setup uses filtering and drying near the compressor, plus a further filter close to the cutter's air inlet. Drain traps regularly, change filter elements when the maker says so, and keep air lines short and direct. If parts wear far faster than expected, check the air supply before blaming the consumables.
