0 items in your basket
Total £ 0.00 EX VAT
MIG Gloves
TIG Gloves
Baseball Caps
Armguards
TIG Heat Blockers
Shop 55,000 Products
SERVICEDEPT.
RAPID BLOG
FEEDBACK
HIRE
Strong and durable hand shield. Built for lenses of 4 1/4" x 3 1/4".
Answers for buyers choosing a passive helmet or hand shield with a fixed-shade lens, and looking after it.
A passive lens has one shade, so choose it carefully for the work you do. The right shade depends mainly on the welding process and the current, with higher current needing a darker lens. Use the shade table in the helmet manual or a recognised shade chart, and prefer the suggested shade rather than the minimum.If you weld across a wide current range, a single shade may not suit everything, and you may need more than one lens. A shade that is too light does not give enough protection from the arc. Your risk assessment and the maker's instructions should have the final say.
On a flip-up helmet the shaded welding lens sits in a hinged front. Lift it and you can see through a clear lens behind, which is useful for chipping slag, brief grinding, setting up and inspecting your work without taking the helmet off.Lower the front before you strike the arc. The clear lens is for general protection and not for arc radiation, so never weld with the front flipped up. Check the maker's instructions for the impact protection the helmet gives and which tasks it is suitable for.
The clear cover lens sits in front of the shaded lens and takes the spatter, scratches and knocks. Replace it when it is scratched, pitted or hazy, because a damaged lens hampers your view and can let you work with poor visibility.If the shaded lens itself is cracked or damaged, replace that too, and never use a cracked lens. Fit a lens made for your helmet, as sizes and holders vary. A simple habit is to check the lens each time you put the helmet on, and keep spares to hand so you do not carry on with a damaged one.
Passive helmets and shields take lenses in a few standard sizes, and the lens must match the holder in the helmet. Look at the maker's data on the helmet or in the manual, or measure the existing lens carefully, to find the width and height.A larger lens gives a wider view of the work but is not always better, since it also depends on fit and the shell design. Use a lens made for your helmet, and take care that the shade and the marking suit your work. If you are unsure, our team can help you choose.