Rapid Ref : 907854001XP

Miller Deltaweld 500 Pulsed MIG/MAG Welder Package - 400v, 3ph
907854001XP

Name: Miller Deltaweld 500 Pulsed MIG/MAG Welder Package - 400v, 3ph
SKU: 907854001XP

Select Option

Prices From £7912.00 ex VAT

The Deltaweld system is designed for advanced manufacturing and is equipped with weld processes developed by Miller to increase productivity and/or increase the quality of the weld. Programs have been developed to suit applications such as:

Out of position welding with solid and flux cored wires.
High deposition on thick material.
Pipe root and gap filling on thin materials.
Low spatter and adaption to poor parts fit-up.

Intellx Ex-S wire feeder

Designed for durability - The strongest and most durable drive system on the market, ensuring consistent and reliable wire feeding regardless of the environment.
Designed for productivity - Loaded with weld processes to increase the deposition rate on thicker material and eliminates the need for a TIG root run on pipe applications.
Designed for quality insurance – Equipped with tools to ensure that correct weld parameters are used.

Brochures & Manuals

BROCHURES & MANUALS

View Brochure

415v MIG Welders FAQs

Straight answers to the questions people ask most when choosing a three-phase MIG welder for workshop and production use.

Who needs a three-phase MIG welder?

Three-phase machines suit fabrication shops, production lines, engineering workshops and anyone welding thicker material or for long periods. A three-phase supply carries more power for a given current per phase, so these machines can give higher output with a steadier load on the supply.

If you only have a single-phase supply, you are limited to single-phase machines.

What is the difference between 400v and 415v on these machines?

In practice, very little. Older documents and some machine labels refer to 415v, while the current nominal figure for a UK three-phase supply is usually given as 400v. Machines are normally designed to work within a tolerance either side of their rated input, but the allowed range depends on the maker and the model.

Check the data plate and the manual for the supply the machine accepts, compare that with the measured supply at your site, and ask a qualified electrician if you are unsure.

Do I need special wiring or a fuse rating to install one?

Yes, it needs a three-phase connection with the correct cable size and protection for the machine's input current, installed by a competent electrician. The manual states the recommended supply cable and fuse or breaker rating.

Do not connect a machine to a circuit that has not been checked for the load. Poor supply causes tripping, overheating and unreliable welding.

What does a high duty cycle give me?

Duty cycle is the proportion of a ten-minute period the machine can weld at a given current before it must cool. A higher duty cycle at your working current means fewer interruptions on long welds.

If you weld continuously at high current, look at the rating at that current rather than the headline maximum.

See all 6 questions for this category