Fronius TTG2200 TIG Torches FAQs
Answers on choosing and using a higher-rated gas-cooled manual TIG torch for heavier, longer TIG welding.
At what point is a water-cooled torch the better choice?
For heavy, sustained work at high current, a water-cooled torch is usually the better option. Its cable is lighter and more flexible, and its consumables tend to last longer, but it needs a cooler unit and coolant, so setup and upkeep are more involved.
A gas-cooled torch is simpler to set up and move, and can be a good fit when welding is intermittent. If you find the handle getting uncomfortably hot, or you are regularly waiting for a torch to cool during long welds, it is worth looking at a water-cooled option. The maker's duty cycle figures are the place to start.
How can I tell my torch is overheating, and what should I do?
Typical signs are a handle or cable that gets too hot to hold comfortably, discoloured or soft collets that no longer grip the tungsten, and collet body threads that seize. Running above the torch's rating is a common cause, as is cutting the post-flow gas short while the head is still very hot.
Stop welding and let the torch cool, then check the settings against the rating and duty cycle. Do not carry on at the limit. Check the collet and other consumables for heat damage and replace any that are discoloured or distorted. Follow the manual for your torch.
What is a flexible torch body good for on a heavier-duty torch?
A flexible body lets you bend the neck to the angle you need, which helps with limited joint access and awkward angles, for example around pipework, frames and corners. It can save you contorting your wrist to reach the joint.
Set the angle for the job and avoid repeatedly bending and straightening the neck, as this can wear it over time. For long, open welds a rigid body is often steadier. Check the manual for the maker's guidance on bending, and bear in mind a flexible neck is only suitable if its rating covers your welding current.
Do I need a torch with a gas valve?
A gas valve in the torch lets you control the shielding gas at the handle. It is needed mainly when the welding machine has no gas solenoid of its own to switch the gas on and off. If the machine does control the gas, a torch without a valve is the normal match.
Check your machine manual to see how it handles gas. A valved torch can also be handy on a machine without pre-flow and post-flow settings, but you then need to leave the gas on long enough after the arc stops to protect the tungsten and the weld.