0 items in your basket
Total £ 0.00 EX VAT
MIG Gloves
TIG Gloves
Baseball Caps
Armguards
TIG Heat Blockers
Shop 55,000 Products
SERVICEDEPT.
RAPID BLOG
FEEDBACK
HIRE
The Paton StandardCUT-45 MAXflow inverter plasma cutter is designed for manual plasma arc cutting of metals and alloys in an air stream, enabling high precision cuts in metals of different textures and thicknesses up to 10mm. A single-phase 230V power supply powers the cutting machine in the ‘Standard’ series and combines high power with ease of use and small dimensions. This machine is suitable for use in both private and professional workshops. Thanks to the built-in compressor, it does not require an additional source of compressed air and is distinguished by its ease of set-up and use, compact size and convenient operation.
PATON MMA Cable Kit, 3m Electrode Lead with 3m Earth Return, 10mm²
PATON Quick Gas Connector
PATON 4m PT-31 Plasma Torch
PATON 1 Year Warranty
Straight answers to the questions people ask most when choosing and using single-phase 230 volt plasma cutters.
Check the machine's data plate for its input current, then make sure the circuit, socket, plug and fuse or breaker are rated to match. A standard 13 amp domestic socket is not suitable for every machine, and some need a dedicated higher-rated outlet.If your machine needs more than a normal socket can give, have a qualified electrician install a suitable supply rather than modifying the plug or fuse. The manual states the recommended protection.
Plasma cutters draw a large current, especially at start-up and when cutting at full output. A circuit that is too small, shared with other equipment, or fed through a long thin lead will trip.Try the machine on a dedicated circuit with a short, appropriately rated lead, and avoid running other heavy loads at the same time. If it still trips, have the circuit and the machine checked rather than fitting a larger breaker than the wiring allows.
It depends on the machine's rating. Single-phase machines are limited by the current a normal circuit can supply, so their maximum cut thickness is lower than a larger three-phase machine of the same type.Compare the recommended cut thickness, not just the severance figure, since the recommended figure is what gives a clean, practical cut. If you will often work near the top of a machine's limits, choose a more powerful machine.
Often, yes, but the generator must be large enough for the machine's input rating and give a stable voltage. An undersized or poor-quality generator can cause the arc to cut out and may damage electronics.Compare the machine's input power on its data plate with the generator's continuous rating, leave a margin, and check the generator maker confirms it is suitable for welding or cutting equipment.