0 items in your basket
Total £ 0.00 EX VAT
MIG Gloves
TIG Gloves
Baseball Caps
Armguards
TIG Heat Blockers
Shop 55,000 Products
SERVICEDEPT.
RAPID BLOG
FEEDBACK
HIRE
Water based silicon free Anti Spatter Spray. For use on all forms of welding to prevent the adhesion of spatter. Apply to workpieces, shrouds & nozzles as well as jigs, tools & fixtures.
Practical answers on where and how to use anti-spatter products, choosing between types, and getting clean results afterwards.
Apply it to the surfaces you want to keep free of spatter: the workpiece either side of the joint, jigs, clamps and fixtures, and the outside of the torch nozzle or shroud. One maker's data sheet lists workpieces, nozzles, shrouds, jigs and tools as suitable surfaces for its water-based product.Keep it away from the contact tip bore and gas ports unless the torch maker says otherwise, as anything that blocks gas flow can cause weld faults. Apply it to cool surfaces before welding starts and let it settle or dry as the label directs.
Less is usually better. Shake an aerosol well, hold it at the distance the label recommends and spray sparingly to give a thin, even film. A thin film works better than a heavy wet coat, which can run, collect dirt and, with some products, affect the weld.Spraying distances and drying times differ between products, so follow the instructions for yours. Wipe off any pools. If you see pores or smoke from the weld area, you may be using too much.
It depends on the job. Aerosols are quick and convenient for occasional use and awkward spots. Pump sprays and bulk containers suit workshops that use a lot and want to refill a trigger or pump bottle. Gels and dips are generally used for torch nozzles and contact tips rather than large work areas.Check that the product is made for your use, and remember that any container should be kept closed and stored as the label says. Our team can help you choose a type to suit the welding you do.
Anti-spatter makes spatter easier to remove but does not stop all of it. TWI notes that spatter can be removed by grinding, which is time-consuming, or quickly with a chipping hammer or spatter chisel without damaging the parent metal. Use eye protection and gloves, as loose spatter can fly off.Spatter that sticks hard, or that appears in large amounts, is often a sign of the wrong settings rather than too little spray. Check wire feed speed, voltage, gas flow and the condition of the contact tip before blaming the product.