Beta e90 SFA with PFU PAPR Parts FAQs
Replacement filters, spark shields, hoses, head covers and fittings for a powered air-purifying welding helmet system, and how to choose the right ones.
How do I find the right replacement part for my powered air welding helmet system?
Start with the label on the blower unit and the parts list in the manual. Makers say the blower label shows the helmet, hood and filters that make up the approved system, so use only the components listed there. Note any part number on the old item.
HSE guidance says replacement parts should ideally come from the original manufacturer, so the equipment keeps performing as intended and gives the protection the maker states. Do not swap in an unlisted part to make something fit. If you cannot match a part from the label and the manual, ask our team before ordering.
What do the pre-filter and the particle filter each do?
The pre-filter is a coarse outer filter that protects the main particle filter behind it. HSE notes that some manufacturers recommend pre-filters for exactly this reason. The particle filter does the fine filtering that protects you from welding fume.
The pre-filter is often the item changed more frequently, but how often depends on the maker, the work and the amount of fume, so follow the manual. Both must be the types listed for your blower. Particle filters do not remove welding gases, so they are no substitute for good ventilation and extraction.
What is the spark shield for, and when should it be replaced?
A spark shield (spark guard) covers the filter inlet. Maker instructions for powered welding respirators say not to use the unit without a properly installed spark guard, because welding sparks may ignite or damage the filter and let unfiltered air in.
Replace it if it is deformed, burnt through, torn or no longer fits closely. Check it along with the filters before use. Use only the shield made for your blower, because a loose or wrong-fitting one can leave gaps. The material and design vary between systems, so follow the manual.
How do I look after the battery and charger?
Use only the battery and charger the manufacturer specifies, and do not use a battery that is damaged. Follow the maker's storage, charging and care instructions, because battery condition affects how well a powered respirator performs.
HSE guidance says the battery should be fully charged before use and that battery charge and flow rate are key maintenance checks. Batteries wear with use, so run time gradually shortens, but a clogged filter has the same effect. Storage and charging advice varies between makers, so follow your manual.