0 items in your basket
Total £ 0.00 EX VAT
MIG Gloves
TIG Gloves
Baseball Caps
Armguards
TIG Heat Blockers
Shop 55,000 Products
SERVICEDEPT.
RAPID BLOG
FEEDBACK
HIRE
Includes one set of general purpose consumables:
420120 Electrode420211 Swirl ring420114 Retaining Cap420118 Nozzle420116 Shield
Answers for choosing, using and looking after a hand-held plasma cutting torch.
A hand torch has to be matched to the power source it connects to, so start with the data plate and the operator manual for your cutter. They give the model, the maximum cutting current and the type of torch connection, and the torch listing should name the cutters it suits.The torch and its consumables are a matched set. A torch that fits the connector but is designed for a different current range can run badly or wear parts quickly, so do not rely on the plug fitting alone. Our team can help you match a torch to your machine if you give them the details from the data plate.
Moisture and oil in the supply air cause an unstable arc, poor cuts and faster wear of the electrode and nozzle. Trade guidance on plasma cutting advises clean, dry air and notes that moisture filters or dryers help extend consumable life.Fit the filtration the cutter's manual calls for, keep it drained and replace filter elements when they are due. Short consumable life that comes and goes with the weather can point to damp air, since humidity changes through the year. Check the pressure and flow at the cutter against the manual, as both affect the arc.
Move at a steady speed. Going too slowly tends to leave dross and a wide cut, while going too fast can leave the arc lagging and the cut unfinished. Look at the sparks beneath the plate: they should trail slightly behind the torch.Hand cutting is normally done with the torch held at the height the consumables are designed for, which depends on the type of shield and the material thickness. When you need to start in the middle of a plate, a pierce takes more clearance than cutting, so start from the edge where you can. Stretching the arc to reach the metal wears consumables sooner. The cutter's manual has cut charts for your machine.
Run your hand and eye along the lead from the handle to the connector and look for cuts, cracks, kinks, crushed sections and exposed wires. Also look at the torch body for cracks. Do this with the cutter disconnected from the mains supply.A lead that is cut or cracked should not stay in use, and a damaged lead or body should be replaced by a qualified service technician. Maker guidance suggests regular inspections at intervals set in the manual. Avoid driving vehicles over the lead, pulling it round sharp edges or leaving it in a tight coil while working.
