0 items in your basket
Total £ 0.00 EX VAT
MIG Gloves
TIG Gloves
Baseball Caps
Armguards
TIG Heat Blockers
Shop 55,000 Products
SERVICEDEPT.
RAPID BLOG
FEEDBACK
HIRE
The 270i is one of Fronius’ finest TPS/i C Pulse range.
This series of machines contains all the advantages of the TPS/i systems and is designed into a more compact power source. This line of equipment ensures a tremendously powerful alternative that saves valuable space and is transportable in different kinds of workshops and construction sites. This machine is equipped with the Pulse process as standard.
Fronius - MTG 320i Gascooled MIG Torch - FSC/UD/3,5m/45°/LED
Fronius - Welding Process Standard
Fronius - TPS 270i C Pulse MIG Welder Power Source, 400v 3 Phase, 4R & FSC Connection
Fronius - TU Car 4 Standard
Fronius - Ground Cable 50mm² 4m 400A 60% Plug 50mm² Earth Clamp
Fronius Feeder roll U 1.2 (4 of)
Fronius - Consumable Kit Steel 1.0mm /G/W/5m
Fronius - Wear Part Kit MTG320i ø1,0
Straight answers to the questions people ask most when choosing a three-phase MIG welder for workshop and production use.
Three-phase machines suit fabrication shops, production lines, engineering workshops and anyone welding thicker material or for long periods. A three-phase supply carries more power for a given current per phase, so these machines can give higher output with a steadier load on the supply.If you only have a single-phase supply, you are limited to single-phase machines.
Yes, it needs a three-phase connection with the correct cable size and protection for the machine's input current, installed by a competent electrician. The manual states the recommended supply cable and fuse or breaker rating.Do not connect a machine to a circuit that has not been checked for the load. Poor supply causes tripping, overheating and unreliable welding.
Air-cooled torches are simpler and need no extra equipment, and suit many general jobs. Water-cooled torches carry higher current for longer without overheating, so they suit heavy, continuous or production welding, but they need a cooler and a little more upkeep.Choose according to the current and the duty cycle you will use.
A compact machine has the wire feeder built into the power source and is simpler and easier to move. A separate (split) system has an independent wire feeder connected by an interconnecting cable, which you can carry to the work, away from the power source.Separate feeders suit large fabrications and reaching big workpieces, and compact units suit general workshop use.