0 items in your basket
Total £ 0.00 EX VAT
MIG Gloves
TIG Gloves
Baseball Caps
Armguards
TIG Heat Blockers
Shop 55,000 Products
SERVICEDEPT.
RAPID BLOG
FEEDBACK
HIRE
The G30 is a unique design in flip front welding and grinding helmets. The visor provides effective protection from UV and IR radiation, whether open or closed, and is available in different shade levels. The helmet is equipped with a strong and comfortable headgear.
Practical answers on choosing, using and looking after welding and weld-and-grind helmets, including flip-up and air-ready styles.
Arc eye is an injury to the front surface of the eye caused by the ultraviolet radiation from welding. The eye usually becomes painful and red a few hours after exposure, and it often feels gritty. Most cases are temporary, but other parts of the eye can also be damaged by welding radiation.The usual cause is striking an arc before the helmet is in place, or being exposed to someone else's arc. If you suspect arc eye, stop work and get medical advice. Always lower the helmet or check the filter is dark before you strike the arc.
Yes. Anyone close to an arc, including helpers, assistants and passers-by, can be exposed to harmful radiation and may develop arc eye. The risk depends on how close they are and how long they are exposed, and there is no distance that is simply safe. People working near the arc need protection suited to the work, such as filtered eyewear with side protection, as set out in your risk assessment.Where possible, screen off the welding area with screens or curtains made for welding, and keep unprotected people well away from the arc. A helmet protects only the person wearing it.
A weld and grind helmet has a hinged front that carries the welding filter. With the front down you weld; with it lifted you see through a clear inner visor, which is useful for grinding, chipping slag and setting up between welds without taking the helmet off.This suits fabrication and repair work where you switch often between welding and preparation. Because the front is a moving part, check the hinge is smooth and holds its position, and that the clear visor is undamaged. Following the maker's instructions on which part protects you in each mode is important.
Welding eye and face protection is made to British and European standards covering the frame, the filter and impact resistance. The markings on the helmet and filter usually show the standards it meets, the shade or shade range, an optical quality class and an impact letter, which indicates how much impact the part was tested to withstand.A letter followed by T means the rating also applies at temperature extremes. The meanings are set out in the helmet manual, which is the authority for your helmet. If markings are missing or illegible, do not rely on the helmet.
