0 items in your basket
Total £ 0.00 EX VAT
MIG Gloves
TIG Gloves
Baseball Caps
Armguards
TIG Heat Blockers
Shop 55,000 Products
SERVICEDEPT.
RAPID BLOG
FEEDBACK
HIRE
4 1/4" x 2" Back Lens BS679
Answers to common questions about welding helmet filter lenses and cover lenses, from shade numbers to fit and fogging.
The filter lens is the dark lens that actually protects your eyes from the arc. A cover lens is a clear, replaceable plate fitted in front of it (and sometimes behind it) to take the spatter, scratches and grime so the filter stays in good condition.Cover lenses are not a substitute for a filter and are not dark. They are normally the part you replace most often, and they should be changed when they are scratched, pitted or hazy enough to hamper your view.
No. A cracked, pitted or otherwise damaged filter or cover lens can reduce your vision and weaken the protection the helmet gives you, and a damaged filter may let harmful ultraviolet and infrared radiation reach your eyes. Helmet makers say to replace damaged lenses and cover plates straight away rather than carry on working.Inspect your lenses before each job. Replace the cover lens as soon as it is scratched, cracked, pitted or covered in spatter, and replace the filter if it is cracked or damaged. Check the manual for the correct part.
These processes use much lighter filters than arc welding. Gas welding, brazing and flame cutting use the lighter end of the shade scale, with the shade rising with the size of the flame or the oxygen flow, while arc welding and arc cutting use darker filters that rise with the current.Use the shade given in the maker's chart or the welding filter standard for your task and flame size. Shade charts often allow the next lighter or darker shade within the recommended range if the conditions call for it, but do not go lighter just to see better.
The shade depends mainly on the process, the welding current and the brightness of the arc. Higher current and brighter processes need a darker lens, and the recommended shade range is set out in the shade charts supplied with filters and in the relevant standard.Start from the maker's chart for your process and amperage rather than guessing. If you wear a helmet with a variable shade lens, set it within the range for your work. A lens that is too light is a risk to your eyes, so do not go lighter than the recommended range just to see better. Better lighting can help instead.