0 items in your basket
Total £ 0.00 EX VAT
MIG Gloves
TIG Gloves
Baseball Caps
Armguards
TIG Heat Blockers
Shop 55,000 Products
SERVICEDEPT.
RAPID BLOG
FEEDBACK
HIRE
This model is a high-capacity combination handle. With proper accessories, it can be used for either acetylene or other fuel gases.
Answers to common questions about the nozzles, mixers, heating heads and cutting attachments used with a modular oxy-acetylene torch.
For most welding and cutting jobs the HSE says acetylene pressure should not exceed 0.62 bar (9 psi), unless the equipment has been specifically designed for a higher pressure. Decomposition of acetylene can be triggered more easily and proceed more rapidly if the gas in the hoses is above the pressure recommended by the supplier, so do not simply wind the regulator up to get more heat.The right working setting for a particular nozzle or mixer is on the manufacturer's chart or data plate. Use only a regulator, hoses and torch parts made for acetylene and marked to the correct standards, and follow your own risk assessment.
The HSE says poorly maintained nozzles cause turbulent gas flow, which increases the risk of flashback. Inspect nozzles regularly, make sure they are not blocked by dirt or spatter, and replace damaged ones. Holding the nozzle too close to the workpiece can overheat it and cause a flashback.A flashback can also happen if a flammable mixture of fuel gas and oxygen is left in the hoses when the torch is lit, which is why purging matters. Tips and mixers that are loose or not properly seated are another common problem, so tighten them by hand or as the maker instructs.
An acetylene cylinder contains a porous mass soaked in acetone, so it is built differently from most gas cylinders. HSE guidance says not to drop or jar it and not to roll it across the floor. Keep it upright, and if it has been laid down and returned to upright, leave it for an hour to settle before use.Check the identification and look for damage before use, and turn off all valves after use. In the UK, acetylene cylinders are normally painted maroon, but the label is what identifies the gas. If a cylinder looks damaged, the label is unclear, or it has been involved in a fire or flashback, do not use it and speak to your gas supplier.
The cutting oxygen bore is chosen by the thickness of material, so larger bores are used on heavier plate. Nozzles are made as one-piece or two-piece designs, and the choice depends on the fuel gas, whether the torch is hand or machine operated, and the maker's design. Standard nozzles have a central oxygen bore surrounded by preheat ports.Always match the nozzle to the fuel gas and to the torch or cutting attachment it was made for. The maker's chart gives the recommended gas pressures for each size, so check it rather than guessing from a similar tip.
