0 items in your basket
Total £ 0.00 EX VAT
MIG Gloves
TIG Gloves
Baseball Caps
Armguards
TIG Heat Blockers
Shop 55,000 Products
SERVICEDEPT.
RAPID BLOG
FEEDBACK
HIRE
Complete Heavy-Duty Consumable Feed Kit including metal feed rolls and guide tubes for Kemppi MXF 63 -65 -67 / MSF 53 -55 -57 / MF29 / Kempact 2530 / Kempact Pulse 3000 / Kempact Pulse 3000 MVU / X3 FastMig Wire Feed Mechanisms.
Straight answers to the questions people ask most when choosing and fitting a feed roll kit for a wire feeder.
A feed roll kit is a set of replacement drive rolls for a wire feeder, matched to one wire type and one wire diameter. Many kits also include the wire inlet guide and outlet guide, because these need to be the right size for the wire as well.Kits are normally made for a particular feeder or range of feeders, so the contents differ. Check what is listed for your unit, and use the data plate and manual to confirm the kit suits your feeder before you buy.
In many kit tables, standard feed roll kits are fitted with plastic rolls and heavy duty kits with metal rolls, listed by wire type and diameter. The exact difference depends on the maker and the feeder, and the groove shape for your wire matters more than the roll material.Do not assume a heavy duty kit can replace a standard one or the other way round. Check the kit description, the data plate and your feeder manual, and fit the type the manual lists for your feeder and wire.
Use the least pressure that feeds the wire without slipping. Too much pressure can flatten or deform the wire, which leads to arc instability or burn-back and sheds shavings into the liner. Too little lets the rolls slide over the wire.A commonly used method is to release the tension, feed the wire against a piece of wood, and tighten until the wire stops slipping, then add about half a turn. Reset the pressure every time you change the rolls or the wire.
A four-roll drive spreads the pushing force over more points, so each roll can apply less pressure. That is often helpful with soft wires, flux-cored wire, long cables and heavier-duty work. A two-roll drive is simpler and works well for many everyday jobs.You cannot usually swap between the two types by changing the kit alone, because the feeder itself is built for one or the other. Choose the kit made for your feeder.