Rapid Ref : CK-TS200 Mfr Ref : TS200

CK Trailing Shield for 2 Series Torches with Standard Gas Lens
TS200 CK-TS200

Name: CK Trailing Shield for 2 Series Torches with Standard Gas Lens
SKU: CK-TS200
Price: 79.55 GBP

£79.55 EX VAT

SSP Suggested Selling Price = £159.10 YOU SAVE £79.55

Buy in 3 easy interest free payments of £26.52^† with

For use with CK9 (WP9), CK20 (WP20, HW20), CK100, CK130, CK200, CK230 style torches and all interchangeable competitive torch models. Used with standard 2 Series Gas Lens parts, includes TS200-C Cup Assembly, Special 3 Series TS200 Gas Lens and 25' of 2 Series Argon Hose with fitting.

TIG Accessories FAQs

Straight answers to the questions people ask most when choosing and using accessories for TIG welding.

Do I need a water cooler, and what size?

You need one if you use a water-cooled torch, which is the usual choice for higher currents and long, continuous welding. The cooler circulates coolant through the torch and cable, keeping them cool and allowing a lighter, slimmer cable than an air-cooled torch of the same rating.

Check that the cooler suits your torch and your power supply: its voltage, its water connections, and its capacity to cool at the heat your torch produces. Some machines and trolleys have a cooler built in or a place to mount one.

What is a trailing shield and when do I need one?

A trailing shield is an attachment that fits behind the torch cup and sends a stream of shielding gas over the weld after the torch has passed. Some metals, such as titanium and stainless steel, stay hot enough to oxidise as they cool, so the extra gas protects them while they cool down.

It is most useful for reactive metals and for welds where discolouration is not acceptable. It must match your torch and be fitted so that it follows the weld evenly.

What is a flexible purge chamber used for?

It is a flexible enclosure that you fill with argon and weld inside, so the whole joint and the area round it sit in an inert atmosphere. It is used mainly for reactive metals like titanium, and for jobs where normal gas coverage cannot keep the hot metal clean as it cools.

You place the work in the chamber, purge it until the oxygen level is low enough, and then weld through the sleeves or openings. Follow the maker's instructions, and make sure that any enclosed space is properly ventilated, since argon displaces air.

What are purge flux, backing tape and foil tape for?

They are ways of protecting the back (root) side of a weld from air. Purge flux is a paste painted on the reverse of a stainless steel joint to protect it from oxidation when a gas purge is not practical. Backing tape is stuck to the back of the joint to protect the root. Foil or similar tape is also used to seal the ends and gaps of a joint when it is purged with gas.

Which is right depends on the metal and the job. Flux residue must be cleaned off afterwards, and some industries restrict what may be used, so check the requirements for your work and the maker's instructions.

See all 6 questions for this category