0 items in your basket
Total £ 0.00 EX VAT
MIG Gloves
TIG Gloves
Baseball Caps
Armguards
TIG Heat Blockers
Shop 55,000 Products
SERVICEDEPT.
RAPID BLOG
FEEDBACK
HIRE
Collet Body Gas Saver LD 2.
Answers to the questions buyers ask when choosing, fitting and looking after the replacement parts for a TIG gas saver (gas lens) torch set-up.
A gas saver, often called a gas lens, replaces the plain collet body with one that has fine layered mesh screens in the gas path. The screens straighten the shielding gas into a smoother, less turbulent column around the tungsten and weld pool.The smoother flow gives more even coverage and lets you extend the tungsten further, which helps in awkward joints and for seeing the weld. Do not assume you can cut the gas flow rate; use the figure recommended for your torch, cup and job.
A typical set-up has a gas lens body with its mesh screens, a collet to grip the tungsten, a backcap with a gas-sealing O-ring, an insulator and a ceramic cup. The O-ring and cup are the usual wear items, along with the collet if it stops gripping the tungsten.The mesh screens can also become discoloured, blocked or damaged. Check each part when the torch is stripped down and replace anything worn, cracked or distorted.
Gas saver parts are made for particular torch families, for example one family covers some torch types and a different family covers others. The gas lens body, cup and insulator usually need to belong to the same family. Parts that look alike can differ in thread, length and diameter.Check the torch type marking and the manual, and compare the old part with the new one before ordering. Our team can help you identify the right part if you are unsure.
Cups are numbered by the diameter of the opening, so a higher number means a wider opening. A larger cup gives wider gas coverage, while a smaller one reaches into tight joints more easily. Gas lens set-ups are usually used with larger cups, and a longer cup lets you extend the tungsten further while keeping it inside the gas shield.A gas saver cup normally needs to be the type made for gas lens use. Check the cup size and gas flow against the torch maker's guidance.