0 items in your basket
Total £ 0.00 EX VAT
MIG Gloves
TIG Gloves
Baseball Caps
Armguards
TIG Heat Blockers
Shop 55,000 Products
SERVICEDEPT.
RAPID BLOG
FEEDBACK
HIRE
Lens dimensions: 51mm x 108mm.
Straight answers on choosing, fitting and looking after the spare parts for a welding helmet with a battery-powered air-purifying blower.
Change a filter that is damaged or visibly contaminated, or that has become harder to breathe through or restricts the airflow. This can happen quickly in very dusty conditions. For filters used with fan-assisted respirators, the manufacturer sets the change interval, so follow the manual.Many blowers also have an airflow or filter warning; if yours does, take it seriously and stop welding to fix the cause. Never use a filter past its shelf-life date, and it helps to mark the date a filter was fitted.
Use the manual, the data plate on the blower and the markings on the old part. Helmets, blowers, hoses and filters are normally designed as a matched system, and one set of parts may not suit another even if it looks similar.Note the full part number or marking from the old part and compare it with the new one. Do not rely on size alone. Parts for different helmet versions in the same range can differ, so if you are unsure, our team can help you match the part to your equipment.
Check the battery condition and airflow before every use, as the manufacturer instructs. Trade guidance for powered respirators also suggests checking the airflow level or battery status again during long shifts, for example after four hours and then every two hours, though the interval depends on your manufacturer and risk assessment.If the airflow drops or the low-flow warning sounds, leave the fume area, following your RPE procedure, and change or recharge the battery in clean air. Charge the battery as the maker describes.
Inspect the hose and its connections before each use for cracks, kinks, splits or loose fittings, because a damaged hose can leak air or restrict flow. Keep it away from sparks, spatter and sharp edges, and route it so it does not snag.Wipe it clean as the manufacturer advises, and let it dry before storing it. Do not use solvents unless the manual allows them. Replace a damaged hose rather than repairing it with tape.