Fronius Feed Rolls FAQs
Straight answers to the questions people ask when choosing, fitting and looking after wire feed rolls for a MIG machine.
How do I match the roll to my wire diameter?
Each groove is made for a particular wire diameter, so the roll must match the wire you are feeding. A mismatch can cause slipping, an erratic arc or wire that is deformed or shaved on its way through.
The size is normally marked on the roll or listed in the machine's parts list, so check the manual for your feeder. Some rolls have a different groove on each face, so make sure the groove you want is on the outside, facing the wire, when you fit it.
What is the difference between two-roll and four-roll feeders?
A two-roll feeder has one pair of rolls gripping the wire and is common on lighter-duty machines. A four-roll feeder has two pairs, giving a larger area of grip, so less pressure is needed at any one point and the wire is less likely to be deformed.
Four-roll feeders are generally preferred for heavy industrial use and for soft wires, but two-roll feeders also feed a range of wires. This depends on the machine, so check the manual for the rolls your feeder takes.
How tight should the roll pressure be?
Too little pressure lets the wire slip in the rolls, while too much flattens or deforms the wire and causes feeding problems and an unstable arc. Aim for the lowest pressure that feeds the wire reliably.
One common method with a cold torch is to loosen the pressure until the wire slips, then tighten in half-turns until it feeds without slipping, either checking against a wooden block or by holding the wire with a gloved hand. Follow the maker's instructions for your feeder, and wear gloves as the wire can be hot.
How do I know when feed rolls are worn?
Feed rolls are wear parts and knurled rolls in particular wear out, so inspect them regularly. Worn rolls become less effective at moving the wire, so you may see erratic feeding or slipping even when the pressure is set correctly.
Do not simply tighten the pressure to cover slipping, as this can flatten the wire and wear the liner and tip faster. There is no fixed replacement interval, as it depends on the wire, the amount of welding and the settings.