0 items in your basket
Total £ 0.00 EX VAT
MIG Gloves
TIG Gloves
Baseball Caps
Armguards
TIG Heat Blockers
Shop 55,000 Products
SERVICEDEPT.
RAPID BLOG
FEEDBACK
HIRE
The NEW Hypertherm Max control gouging shields allow for more precise metal removal. The new Max Control gouging shield allows you to achieve shallow gouging profiles and light material washing applications.
Questions buyers ask when choosing, fitting and looking after replacement consumables for this style of plasma cutting torch.
Electrodes have a small insert at the tip that wears into a pit as you cut. Some pitting is normal, but once it reaches the maker's limit the arc can damage the copper body and the torch can be harmed quickly. Some makers set the limit by cutting current, so use the figure in your manual. Replace the nozzle at the same time as the electrode.Other warning signs are a wandering or unstable arc, hard starting, and needing to slow down to get through the metal.
Usually yes. The nozzle and electrode wear together and an old part can spoil the life and cut quality of a new one, so makers generally recommend changing them as a set.A nozzle should be replaced when the orifice is nicked, out of round or has rounded edges, or when the cut becomes angled, rough or covered in dross. Look at the orifice in good light. If the hole is no longer a clean circle, replace it rather than trying to clean it up.
A shield sits at the front of the torch and protects the nozzle from molten spatter and double arcing. On hand torches, a shield also lets you rest the torch on the plate and drag it along the cut, which keeps the standoff consistent.Unshielded parts need a controlled standoff and may give slower speeds, more dross and shorter nozzle life. On machine torches that sense the plate surface by electrical contact, a special conductive shield and retaining cap are usually needed, so check the maker's chart before ordering.
Gouging removes metal from the surface instead of cutting through it, for example to remove a weld or a defect. Gouging nozzles generally have a wider orifice that gives a wider, softer arc, and some torches use a dedicated gouging shield as well.Gouging parts are made for a particular torch and current range, so use the parts the maker's chart lists for your torch, current and task. Do not fit gouging parts for through-cutting or the reverse, as cut quality will suffer.