0 items in your basket
Total £ 0.00 EX VAT
MIG Gloves
TIG Gloves
Baseball Caps
Armguards
TIG Heat Blockers
Shop 55,000 Products
SERVICEDEPT.
RAPID BLOG
FEEDBACK
HIRE
Practical answers on choosing and looking after the replaceable parts of a powered or supplied air welding helmet system.
Check that the hose and sealing parts are free from any visible damage, and that the hose is fitted correctly to both the blower or air source and the head part. Maker instructions for supplied and powered air equipment ask for this check before every use.The HSE also says respiratory protective equipment must be thoroughly inspected before each use. Look for cracks, cuts, kinks, hardened or flattened seals and loose connectors, and replace anything damaged before you weld. Do not tape or patch a damaged hose, because the protection depends on the air path being sound.
For parts that affect the air path or the seal, yes, you should stay with parts the maker approves for your system. Maker manuals state that all parts of the system must be approved by the manufacturer and used in line with the instructions, and buying guides warn against unapproved filters and face seals.A part that looks the same may differ in size, material or flow resistance, and a poor fit can reduce the protection you rely on. Check the manual's parts list against your helmet and blower or air source, and if you are unsure, ask our team to help you match the part.
A powered system's particle filter should be replaced according to the maker's schedule and sooner if it is damaged, clogged or the airflow warning shows. Do not clean or blow out a filter to extend its life. One maker's manual makes clear that damage caused by cleaning or blowing a filter is not covered, and that a late change is a misuse.The interval depends on the maker, the filter type and how dirty the work is, so use the manual and your risk assessment rather than a fixed figure. Keep a spare set of filters so you are never tempted to carry on with a worn one.
Sealing rings and similar gaskets close the joints between the hose, the head part and the air source so air flows through the filter and tube rather than leaking. Straps and neck pieces hold the hose in a comfortable position and keep it from pulling on the connection.Replace any seal that is cracked, flattened, hardened, torn or no longer grips, and replace damaged parts straight away because a leak or a loose hose reduces protection. Fit the new part exactly as the manual shows, and check the joint again after fitting.