Rapid Ref : 01C5040 Mfr Ref : 01C.5040

Protec Matallotion CE15L Anti Spatter Spray, 0.4Ltr
01C.5040 01C5040

£6.21 EX VAT

Bio Anti Spatter Lotion, ready to use, water-based, silicone-free.

Characteristics:

METALLOTION PROTEC CE15L is a non-flammable Anti Spatter Lotion to spray on workpieces and jigs.
CE15L takes effect in wet and dry phase.
CE15L is also a temporary corrosion protector.
CE15L is non-toxic and biodegradable.

Advantages:

METALLOTION PROTEC CE15L is tested and approved for welding, painting, electro-coating, powder-coating, zinc-coating, galvanisation.
CE15L is approved for automotive industry, traffic engineering, off-shore technology, container engineering, steel construction, crane industry, no pores arise in the welding seam.
CE15L is a protecting and degreasing agent for all kinds of metal surfaces -a subsequent fine cleaning is sufficient.

Customer Benefits

Cost catcher and time saver because post-treatment is being cancelled higher quality by spatter free metal surfaces cost-benefit factor > 100%, pre-treatment for every type of coating technology does not form residues.

Anti-Spatter FAQs

Practical answers on where and how to use anti-spatter products, choosing between types, and getting clean results afterwards.

Where should I apply anti-spatter?

Apply it to the surfaces you want to keep free of spatter: the workpiece either side of the joint, jigs, clamps and fixtures, and the outside of the torch nozzle or shroud. One maker's data sheet lists workpieces, nozzles, shrouds, jigs and tools as suitable surfaces for its water-based product.

Keep it away from the contact tip bore and gas ports unless the torch maker says otherwise, as anything that blocks gas flow can cause weld faults. Apply it to cool surfaces before welding starts and let it settle or dry as the label directs.

What is the difference between water-based and solvent-based anti-spatter?

Water-based products use water as the carrier, so they are often non-flammable and give off fewer solvent fumes. One maker's data sheet describes its water-based spray as non-flammable and rinseable with water. Solvent-based products often dry faster and cling well, but many are flammable and need more care with storage and use near sparks.

The label tells you which you have, so check it and the safety data sheet before choosing. If you work in an enclosed space or near a heat source, a non-flammable water-based type is often the more comfortable choice.

Is a pump spray, aerosol or dip better for anti-spatter?

It depends on the job. Aerosols are quick and convenient for occasional use and awkward spots. Pump sprays and bulk containers suit workshops that use a lot and want to refill a trigger or pump bottle. Gels and dips are generally used for torch nozzles and contact tips rather than large work areas.

Check that the product is made for your use, and remember that any container should be kept closed and stored as the label says. Our team can help you choose a type to suit the welding you do.

How do I remove spatter that has stuck despite using anti-spatter?

Anti-spatter makes spatter easier to remove but does not stop all of it. TWI notes that spatter can be removed by grinding, which is time-consuming, or quickly with a chipping hammer or spatter chisel without damaging the parent metal. Use eye protection and gloves, as loose spatter can fly off.

Spatter that sticks hard, or that appears in large amounts, is often a sign of the wrong settings rather than too little spray. Check wire feed speed, voltage, gas flow and the condition of the contact tip before blaming the product.

See all 6 questions for this category